Posted inFeatured
Posted inAdvanced Concepts
How To Check Accidental Torsion In Etabs Using Static Seismic Loads
I hope you would bear with this rather lengthy post. I have received an email…
Posted inAdvanced Concepts
Tips In Checking Service Crackwidths Using Bs 8110-2:1985
When acted upon by service loads, a structural element especially those that are predominantly resisting…
Posted inAdvanced Concepts
Rotating Spectral Axes
(Before anything else, I would like to acknowledge our design manager Dale who unselfishly shared…
Posted inAdvanced Concepts
Setting Correct Expectations On Lfrs Involving Transfers
Gravity dictates that what’s up must go down. The same can be said of lateral…
Posted inAdvanced Concepts
Did You Know That… Dynamic Vs Static Base Shear Balancing Is Different In Asce From Ubc97?
If you’ve read my previous post regarding balancing seismic and dynamic base shear that was seismic base…
Posted inAdvanced Concepts
Did You Know That… You Can Go Lower Than The Minimum Required Flexural Reinforcement?
This applies if the reinforcement provided is not driven by crackwidth limits and thermal requirements.…
Posted inAdvanced Concepts
Did You Know That… Strength Reduction Factor Adjusts Depending On The Strain Of The Extreme Tensile Steel?
How old am I? I’ll give you an idea: we had been the last batch…
Posted inAdvanced Concepts
Huge Stuff Re Architectural Mepf That We Need To Put Our Fingers On
Howdy everyone?! I’ve been digging for quite sometime now for something to share with you…
Posted inAdvanced Concepts
Interpreting The Modal Mass Participating Ratios Table From Etabs
I have not been modelling extensively in ETABS this recently so this query from a…
Posted inAdvanced Concepts
Tips In Proportioning The Geometry And Reinforcement Of Conventional Slabs
Slab design may not be that ‘challenging’ to some compared to designing walls and columns…